![]() The page should showĬurrent user's domain, username and authentication type. ![]() Netscaler pass-through configuration should be done correctly in order for thisĬustomization to work. API key (you can view/change it in TOTPRadius admin panel) Properly configured on all 3 components (Netscaler, TOTPRadius and StoreFront) ![]() Enter the IP address of the TOTPRadius appliance. Specify the folder where your Reciever for Web Website is located. Run the installer as administrator on the StoreFront server. The TOTPRadius Storefront integration package and Users that enrolled themselves will still appear on TOTPRadius web interfaceĪnd can be edited, banned or deleted by administrators. On the next login, the user should provide OTP generated by the mobile app in QR code will be shown,Īnd user should scan it with a TOTP mobile application (Google Authenticator, Second-factor authentication for the user immediately. Will use API calls to check if the current user has a TOTP profile enabled onĮnable TOTP, users should click on "enable", then on OK button on the nextĬlicking OK, StoreFront will send an API call to TOTPRadius and enable Should set "Allow initial login" to at least "1" in TOTPRadius Admin Panel toĪllow users to login and enrol second factor authentication. Once installed and configured, users will see anĪdditional status bar in the header prompting users to enable TOTP. Install StoreFront integration package (described below) on all StoreFront Provides a RESTful API service to allow StoreFront integration. User self-enrolment via Citrix StoreFront interface After a lot of searching I was unable to find the registry keys to setup the Receiver to use Pass Through Authentication, but after messing with the ADM file provided with the Receiver I have extracted the below registry keys which will set it up for you. Passwords (Password 2 is the field for OTP). Once done, Netscaler interface will ask for two In Admin Panel of TOTPRadius web interface. "Secondary Authentication Method" to RADIUS and enter the TOTPRadius appliance Click on Editīutton next to the site you want to configure two-factor authentication for. To Netscaler admin panel with nsroot and click on Configuration->XenAppĪnd Xendesktop sites->Configured Virtual Servers. Specify TOTPRadius as secondary authentication for XenApp/XenDesktop Order to enable two-factor authentication on Netscaler gateway, we have to 12 and newer are supported if manually configured (not using a wizard), see details hereĬitrix Netscaler Gateway to use TOTPRadius Note! Currently, Netscaler versions 10.x and 11.x are fully supported.
0 Comments
Leave a Reply. |